JimM's Truck Repair

Jim M

Thanks guys. Randy, the junction boxes and elbows are 3D printed. I've been working with Brett on some drawings of some electrical components. I don't know if or when they will pass the test for being able to be mass produced. These "elbows" took quite a bit of work to fit the conduit and be able to pass the wire through. The junction boxes were drawn specifically for the width of the truss they are attached to and for the conduit tubing that I used.

randyp

Thanks Jim for the information. I hope you and Brett get things worked out. these would be a great addition to the 3D printed parts. Randy

KKarns

Great work here Jim! Looking forward to seeing this piece all lit up. Nice details all around.