I have found the drill bits made by Rodgers are one of the best I have used. They come in a a small base with a cover #80 to #60. They very in price depending on where you get them. Get the Rodger one
I may be a bit late on this thread, but I get my drill bits from Gyros Precision Tools. I have purchased all the drill bits from #50-#80 and use them in my pin vice as well as my Dremel tools. I've
I know you said you're not 100% finished. About the only suggestion I have would be on Picture #8 (the back side with the "Old Gold" sign). I'd make sure to get some weeds and shrubs growing on both
Epoxy the two pieces together and while it's setting, you want to check the hole on the bottom of the barrel for the brass support (piece #8) and the stack (piece #9) to make sure everything will line
thanks- I sometimes think my stuff always looks like it's covered in moon dust- but when you look at photos of the prototypes (in this case the Sierra RR machine shop)- everything looks like it's cove
There are 13 machines in total not counting the electric motor in the prototype - with the SW kits I have them all now. The #812 engine will power the line from outside the shop instead. Plus I need t
For the steam engine (ME-#812) kit the driver wheel is noted as 54" so assuming it has a rotational speed of 200 to 300 RPM, the wheel on the line shaft should then be about the same sizeā¦ makes sens
OK folks, up next is kit #8- the Log Deck. I've been looking forward to this one; lots of wooden structures and some great looking castings. I have a new technique I'll be using on the skidway. I'll d
This was the Eureka Springs Boiler House, mini-scene #8083. I'm attempting to attach some pictures copied from the printed instructions that came with the kit. Personally I found the mini-scenes a g